Rated Power: 
 0.75-125 W / s (joules). Screen can display full (maximum) energy per common ratio (%). Display accuracy of 0.5%, the energy for the selected display resolution of 0.1% - 0.5%. 
 Supply voltage stability: 
 Changes in the nominal supply voltage of + / -13%, it can maintain the capacitor voltage setting of + / -0.25% range. 
 Volume control circuit: 
 When the error amplifier voltage reading off the charging circuit requires more than the value of a resistor connected to the capacitors at both ends, the capacitor discharge to the required voltage level. Insensitive zone volume control circuit for the maximum voltage of about 0.6%. 
 Line fault step-down: 
 This is a safety feature, when the input power suddenly cut off, an automatic step-down resistor connected, the capacitor discharge. 
 Ignition circuit: 
 Require an external ignition closed accounts or low-touch control logic circuit. Internal filtering device to prevent electrical interference (RFI) caused by the ignition off. 
 Power supply voltage: 
 110-230vac, 50/60HZ, 1325 watts of charging, 25 watts standby, when using 110-230v 2A breakers. 
 Welding ignition lock: 
 The output of error amplifier in the charge and discharge intervals to prevent the ignition circuit, which helps prevent the capacitor charge or discharge before the right to power (welding) ignition, caused by poor quality welding results. 
 Programmable pre-press time: 
 Environment with the manual and automatic ignition of non-pressure welding head used, ensure that the welding heat sent before the aligned electrode welding parts, pre-press time, user programmable (range 0.1-9.9 seconds). 
 Remote program selection: 
 4 unipolar input can be used: (a) Remote Option # 1 - # 7 program, (b) remote control to prevent the capacitor charge. Remote program input signal, the panel will select the replacement. 
 Valve Drive Output: 
 Welding head can be controlled pneumatic solenoid valves, 24VAC, 15 A output. 
 Output pulse characteristics: 
 In the power output and even a non-inductive load of 0.01 ohms at both ends of the measured pulse characteristics, the maximum amplitude at zero amplitude and pulse rise time measured between, between points in the 10% of the measured pulse amplitude impulse width. 
 Pulse transformer connected capacitor pulse rise time pulse width of the first pieces of 
 And even the (short pulse) 1500mf 0.65ms 2.3ms 7.0v 
 Concatenated (long pulse) 1500mf 1.05ms 4.0ms 4.5v 
 Welding speed: repetition rate (Rep Rate), which is the rated heat rate in the system, based on the average number of welds per minute, 
 Repetition rate used to determine the average time of up to 20 minutes. The maximum rate of intermittent welding (Hit Rate), which is the power 
 (Welding) the rate of non-continuous weld. Assuming the single-pulse welding is conducted in a way, the process indicators are: 
 Percentage of maximum energy frequency of repetition rate welding / min welding speed intermittent frequency welding 
 2% 265 305 
 25% 85,160 
 50% 62,120 
 100% 45 60 
 OVERALL DIMENSIONS external dimensions Dimensions: 332mm (high) × 230mm (width) × 337mm (length) 
 Weight: 22kg