Current monitoring test: LCD screen to directly view the display on the computer to automatically test the accuracy of each discharge current output, to ensure product consistency, and control is precise, stable, efficient, and in settings beyond the scope of setting current set the alarm automatically. 
 Automatic computer counters: LCD screen display can accurately calculate the number of daily production of the work product. 
 Automatic alarm and cut off the system: such as welding overheating and damage, it will automatically alarm and signals at the same time cut off the welding circuit to prevent further deterioration and to remind the repair of faults. 
 Rated power 0.75-200 W / sec (Joule). Screen can display full (maximum) energy per common ratio (%). Display accuracy of 0.5%, the energy for the selected display resolution of 0.1% - 0.5%. 
 Supply voltage stability: changes in the nominal supply voltage of + / -16%, it can maintain the capacitor voltage setting of + / -0.25% range. 
 Volume control circuit: when the error amplifier is cut off the charging circuit voltage reading exceeds the value required, a resistor connected to the capacitors at both ends, the capacitor discharge to the required voltage level. Insensitive zone volume control circuit for the maximum voltage of about 0.6%. 
 Line fault step-down: This is a safety feature, when the input power suddenly cut off, an automatic step-down resistor connected, the capacitor discharge. 
 Ignition circuit: Ignition require an external contact closure or low total control of logic circuits. Internal filtering device to prevent electrical interference (RFI) caused by the ignition off. 
 Supply Voltage :110-230vac, 50/60HZ, 1325 watt charging, 25 watts standby, when using 110-230v 2A breakers. 
 Welding ignition lock: error amplifier output in the charging and discharging interval to prevent the ignition circuit, which helps prevent the capacitor charge or discharge before the right to power (welding) ignition, caused by poor quality welding results. 
 Programmable pre-press time: the environment and manual and automatic ignition of non-pressure welding head used, ensure that the welding heat sent before the aligned electrode welding parts, pre-press time, user programmable (range 0.1-9.9 seconds). 
 Remote program selection: 4 unipolar input can be used: (a) Remote Option # 1 - # 7 program, (b) remote control to prevent the capacitor charge. Remote program input signal, the panel will select the replacement. 
 Valve Drive Output: welding head can be controlled pneumatic solenoid valves, 24VAC, 15 A output. 
 Output pulse characteristics: the power output and even a non-inductive load of 0.01 ohms at both ends of the measured pulse characteristics, the maximum amplitude at zero amplitude and pulse rise time measured between, between points in the 10% of the measured pulse amplitude impulse width. 
 Pulse transformer connected capacitor pulse rise time pulse width of the first pieces of 
 And even the (short pulse) 1500mf 0.65ms 2.3ms 7.0v 
 Concatenated (long pulse) 1500mf 1.05ms 4.0ms 4.5v 
 Welding speed: repetition rate (Rep Rate), which is the rated heat rate in the system, based on the average number of welds per minute to determine the repetition rate of the average time of up to 20 minutes. The maximum rate of intermittent welding (Hit Rate), which is the power (welding) for non-continuous welding speed. Assuming the single-pulse welding is conducted in a way, the process indicators are: 
 Percentage of maximum energy frequency of repetition rate welding / min welding speed intermittent frequency welding 
 2% 326 362 
 25% 108 180 
 50% 80,145 
 100% 62 83 
 OVERALL DIMENSIONS external dimensions Dimensions: 390mm (high) × 230mm (width) × 377mm (length) 
 Weight: 30kg